Setup and loading
Set the pulley at the lowest position with ankle straps or a foot harness and lie with your head away from the machine, far enough that the cable is taut with legs half extended. Start at the lightest weight and add load only when you can do 12 to 15 reps lifting your pelvis.
How to do the cable reverse crunch step by step
- Attach the ankle straps to the cable, lie on your back facing away from the stack and hold something fixed overhead.
- Bend your hips and knees to 90 degrees with the cable taut and press your lower back into the floor.
- Exhale and draw your knees toward your chest, curling your pelvis and lifting your glutes.
- Squeeze your abs for a second in the fully curled position.
- Breathe in and return slowly to 90 degrees, resisting the pull of the cable.
- Do not let your legs straighten fully or your lower back arch before the next rep.
Form cues
- Lift your pelvis, not just your knees
- Lower back stays down on the return
- Fight the cable as you extend
- Slow tempo, no jerking
Common mistakes
- Too much weight: the cable pulls your back into an arch; reduce load until you control the return.
- Only flexing at the hips: hip flexors take over; focus on lifting your glutes off the floor.
- Straightening your legs fully: you lose ab tension; stop at 90 degrees.
- Jerking with your legs: reduces useful work; start each rep from a dead stop.
How to make it easier or harder
If you cannot control the cable, remove it and do floor reverse crunches or bent knee hip raises. To progress, add weight in small steps or hold a two second pause with your pelvis lifted.
Sets and reps for your goal
Core & Stability
3 x 8-15 or 20-45 s3-4 sets of 20-45 seconds or 8-12 slow reps. Rest 45 to 60 seconds.
Neutral spine, tight abs and controlled breathing. Progress in time or leverage before adding weight.
A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.
Check your form
Film yourself from the side or ask someone to watch, then tick what you get right.
Frequently asked questions
What does the cable add to a reverse crunch?
The cable adds resistance you can increase in small steps and keeps tension early in the movement, where bodyweight barely loads you. That lets you progress without relying only on higher reps.
Where should the pulley be for cable reverse crunches?
At the lowest setting, near floor level, so the cable pulls your feet in line with your body. If the pulley is set high, the angle changes and the resistance no longer works against your abs.