Setup and loading
Use a hook grip at clean width and hip width feet for the first phase. Learn each part separately with light weight, and avoid heavy loads until both the clean and jerk are stable on their own.
How to do the clean and jerk step by step
- Perform a full clean: pull from the floor, extend explosively, and catch in a front squat before standing up.
- Adjust your grip if needed, set your feet hip width apart, and breathe in to brace with the bar on your shoulders.
- Dip your knees a few inches straight down, with weight across your whole foot and torso upright.
- Drive hard through your legs to launch the bar and drop under it, splitting your feet front and back.
- Catch the bar with locked arms, head pushed through the window, and torso tight over your base.
- Recover by stepping the front foot back first and then the back foot forward; exhale and lower the bar.
Form cues
- Fully recover from the clean first
- Make the dip short and vertical, not forward
- Arms locked as your feet land
- Front foot back first to recover
Common mistakes
- Jerking without resetting after the clean: your torso collapses; recover and breathe first.
- Leaning forward in the dip: the bar drives out front; keep your chest up and dip straight down.
- Split too short: your base is unstable; step the front foot out and drop the back knee.
- Locking arms late: it turns into a press out; punch the bar as you drop under.
How to make it easier or harder
To learn, drill hang power cleans and power jerks separately with light weight. To progress, use complexes like clean plus two jerks or block clean plus jerk, or build up to heavier singles.
Sets and reps for your goal
Power
4-6 x 2-5 · full rest3-6 sets of 1-5 reps with light or moderate loads (30-60% of your max on the main lifts), or with a ball or your bodyweight. Rest 2 to 3 minutes.
Every rep at the highest possible speed. As soon as you notice it moving slower (a 10-20% velocity loss), end the set. Train power fresh, never fatigued.
Max Strength
4-5 x 3-6 · rest 2-3 min3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.
Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.
A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.
Check your form
Film yourself from the side or ask someone to watch, then tick what you get right.
Frequently asked questions
What is the difference between the clean and jerk and the snatch?
In the snatch the bar goes from floor to overhead in one motion with a wide grip. The clean and jerk uses two phases, first to the shoulders and then overhead, which allows heavier weights.
Why do lifters split jerk?
The split gives a long, stable front to back base, lets you drop lower under the bar, and leaves more room to save imperfect lifts. That is why most weightlifters use it in competition, though some prefer the power jerk.
Sports it suits
Gear for this exercise
- Olympic barbell and platesTo keep progressing on the big lifts with heavy loads.
As an Amazon Associate, Muscle Atlas earns from qualifying purchases.