Atlas
EZ-Bar Skull Crusher: starting position EZ-Bar Skull Crusher: end position

Elbow Extension · Triceps

EZ-Bar Skull Crusher

A elbow extension exercise that works the triceps. Beginner level, using barbell & rack.

The EZ-bar skull crusher is a lying elbow extension on a flat bench where you lower the bar toward your forehead and press it back up by straightening your arms. The angled EZ-bar grip puts less strain on your wrists than a straight bar. It is a great choice for beginners who want to build triceps size.

BeginnerBarbell & rackGym

Muscles worked

PrimaryTriceps
SecondaryForearms

It works all three heads of the triceps, especially the long head because your upper arm stays flexed in front of your body. Your forearms work isometrically to hold the bar.

Setup and loading

Lie on a flat bench and hold the EZ-bar on the inner bends, hands a bit closer than shoulder width. Start with the empty bar or small plates and add weight only when you can complete 10 to 12 reps without your elbows flaring.

How to do the ez-bar skull crusher step by step

  1. Lie on the bench with your feet planted and hold the EZ-bar on the inner bends.
  2. Press your arms straight above your chest, then tilt them slightly back toward your head to keep tension.
  3. Inhale and bend only at the elbows to lower the bar slowly toward your forehead or just above it.
  4. Stop the bar an inch or two from your forehead, elbows pointing at the ceiling and tucked in.
  5. Exhale and straighten your elbows to press the bar back to the start without moving your upper arms.
  6. Repeat with your shoulder blades pinned to the bench and your lower back in controlled contact.

Form cues

  • Elbows tucked in and pointing at the ceiling
  • Only your forearms move during each rep
  • Lower slowly toward your forehead, never drop it
  • Upper arms tilted slightly back at the top

Common mistakes

  • Flaring your elbows: your chest takes over; keep them in line with your shoulders.
  • Moving your upper arms: it turns into a pullover; lock them in place and hinge at the elbow.
  • Lowering too fast: you risk hitting your head and stress your elbows; control the descent.
  • Locking out with vertical arms: the triceps lose tension; keep your arms angled slightly back.

How to make it easier or harder

To make it easier, try lying dumbbell extensions or use the EZ-bar with no plates. To progress, add load, pause at the bottom, or lower the bar behind your head for a deeper long-head stretch.

Advertisement

Sets and reps for your goal

Hypertrophy

3 x 10-15 · rest 60 s

3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.

Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

Why use an EZ-bar for skull crushers?

The EZ-bar sets your wrists in a semi-pronated position that feels more natural than a straight bar. Many lifters notice less wrist and elbow discomfort and can focus on the triceps through the whole range of motion.

How low should the bar go on skull crushers?

Most people lower it to the forehead or just above. Taking it a little farther back toward the crown of your head increases the long-head stretch, but it requires solid control and usually a slightly lighter load.

Sports it suits

Gear for this exercise

  • Olympic barbell and platesTo keep progressing on the big lifts with heavy loads.

As an Amazon Associate, Muscle Atlas earns from qualifying purchases.

Variations and similar exercises

Advertisement