Atlas
Single-Leg Bench Hip Thrust: starting position Single-Leg Bench Hip Thrust: end position

Hip Extension · Glutes

Single-Leg Bench Hip Thrust

A hip extension exercise that works the glutes. Intermediate level, using bodyweight.

The single-leg bench hip thrust is a one-sided hip extension where your upper back rests on a bench and you drive your hips up through one foot. It isolates each glute, helps fix imbalances, and carries over well to sprinting. It suits intermediate lifters and works at home with a couch.

IntermediateBodyweightGymHome

Muscles worked

PrimaryGlutes
SecondaryHamstrings, Abs

Your glute max extends the hip and does most of the work, while your glute medius stops your pelvis from dropping toward the free side. Your hamstrings assist the extension and your abs control your spine position.

Setup and loading

Rest the bottom of your shoulder blades on a stable bench or couch, one foot planted and the other knee pulled toward your chest. If 15 reps feel easy, add long pauses at the top, slow the descent, or place a dumbbell on your hip.

How to do the single-leg bench hip thrust step by step

  1. Sit on the floor with your upper back against the bench edge and your working foot planted, shin close to vertical.
  2. Pull your other knee toward your chest and hold it, or spread your arms along the bench.
  3. Tuck your chin slightly, pull your ribs down, and let your hips sink toward the floor.
  4. Exhale and drive through your heel until your knee, hips, and shoulders line up, squeezing your glute hard.
  5. Hold for one second at the top with your pelvis level and your lower back neutral.
  6. Inhale and lower under control until your hips nearly touch the floor; finish the set before switching legs.

Form cues

  • Pelvis level, not dropping to one side
  • Drive through your heel, toes relaxed
  • Ribs down, chin tucked
  • Squeeze your glute for one second at the top

Common mistakes

  • Arching your lower back: your spine does the work; keep ribs down and stop at a straight line.
  • Pushing through your toes: it shifts load to the quads; keep weight on your heel.
  • Rotating your hips: the glute medius stops stabilizing; keep both hip bones at the same height.
  • Foot too far out: hamstrings take over; bring it in so your shin is vertical at the top.

How to make it easier or harder

To make it easier, start with a single-leg glute bridge on the floor or a two-leg bench hip thrust. To progress, add a dumbbell on your hip, hold a three-second pause at the top, or elevate your foot on a step for more range.

Advertisement

Sets and reps for your goal

Hypertrophy

3 x 10-12 per leg · rest 60 s

3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.

Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.

Speed

3 x 6 fast per leg

4-8 reps of 10-40 meters (or 3-6 seconds). Full rest: 1 minute for every 10 meters.

Always at 95-100%. If your time gets more than 3-5% slower or your technique falls apart, stop: running tired trains endurance, not speed.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

Does the single-leg hip thrust help you sprint faster?

Single-leg hip extension resembles the push phase of sprinting, and stronger glutes on each side can support that. It works best alongside real sprint training and power exercises.

Where should my back rest during a hip thrust?

Rest the area just below your shoulder blades on the bench edge. Too high strains your neck and too low makes your back arch. A bench around 16 inches tall works for most people.

Sports it suits

Gear for this exercise

As an Amazon Associate, Muscle Atlas earns from qualifying purchases.

Variations and similar exercises

Advertisement