Atlas
Clean Pull: starting position Clean Pull: end position

Olympic Lifts · Quads

Clean Pull

A olympic lifts exercise that works the quads. Intermediate level, using barbell & rack.

The clean pull is the first part of the clean without the catch: you lift the bar from the floor with a clean grip and finish with an explosive extension and shrug. It lets you use more weight than in the clean while reinforcing pulling position and power. It is a key accessory in intermediate Olympic weightlifting.

IntermediateBarbell & rackGym

Muscles worked

PrimaryQuads
SecondaryForearms, Glutes, Hamstrings, Lower back, Traps & mid back

Quads, glutes and hamstrings drive the powerful knee and hip extension while your lower back stays rigid. The traps work in the final shrug and the forearms hold the load in a hook grip.

Technical lift: the photos show the start and end positions. Learn the full bar path with a coach.

Setup and loading

Use the same grip and foot position as your clean. Most lifters train with 90 to 110 percent of their best clean, keeping technique and speed identical on every rep.

How to do the clean pull step by step

  1. Set up as for a clean, with the bar over midfoot, feet hip width and a hook grip.
  2. Breathe in, brace, and break the bar off the floor by pushing through your legs, shoulders over the bar.
  3. Hold your back angle and keep the bar close to your legs until it clears your knees.
  4. At upper thigh, extend your hips, knees and ankles explosively until you rise onto your toes.
  5. Shrug your shoulders toward your ears at the end of the extension, with arms still straight.
  6. Exhale and lower the bar under control, sliding it down your thighs and past your knees to the floor.

Form cues

  • Same start position as your clean
  • Extend tall and vertical, not backward
  • Keep long arms, the shrug comes last
  • Keep the bar on your thighs

Common mistakes

  • Bending the arms during the pull: it steals leg power; keep them straight until the shrug.
  • Leaning back at the finish: it sends the bar forward; finish vertical over your feet.
  • Changing technique with heavy loads: it will not carry over; drop weight if positions shift.
  • Shrugging before extending: it cuts hip power short; extend first, then shrug.

How to make it easier or harder

To make it easier, practice clean deadlifts or pulls from knee height. To progress, add load, pull from a deficit, or pause just below the knee to strengthen specific positions.

Advertisement

Sets and reps for your goal

Power

4-6 x 2-5 · full rest

3-6 sets of 1-5 reps with light or moderate loads (30-60% of your max on the main lifts), or with a ball or your bodyweight. Rest 2 to 3 minutes.

Every rep at the highest possible speed. As soon as you notice it moving slower (a 10-20% velocity loss), end the set. Train power fresh, never fatigued.

Max Strength

4-5 x 3-6 · rest 2-3 min

3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.

Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

What are clean pulls good for?

They strengthen the clean pull with heavier weight than you can catch. They improve position, extension power and confidence under heavy loads, without the technical wear of receiving the bar every rep.

How heavy should clean pulls be?

Typically 90 to 110 percent of your best clean, though some programs go higher. The key is that technique and speed match your clean; if they change, the load is too heavy.

Sports it suits

Gear for this exercise

  • Olympic barbell and platesTo keep progressing on the big lifts with heavy loads.

As an Amazon Associate, Muscle Atlas earns from qualifying purchases.

Variations and similar exercises

Advertisement