Setup and loading
Center a flat bench between two pulleys set to the lowest position. Choose a light to moderate weight that allows 12 to 15 reps with fixed elbows and without the cables pulling you around.
How to do the flat bench cable fly step by step
- Place a flat bench in the center of the cable station with both pulleys at the lowest setting.
- Grab a handle in each hand, sit down and lie back, bringing the handles over your chest with nearly straight arms.
- Pull your shoulder blades together, soften your elbows and plant your feet firmly.
- Breathe in and open your arms in an arc until your hands are about level with your chest, feeling the stretch.
- Exhale and bring your arms back along the same arc until the handles meet over your chest, squeezing for a second.
- When finished, bring the handles together over your chest, sit up and return them slowly to the stack.
Form cues
- Wide arc with elbows locked in place
- Squeeze at the top, tension never drops
- Open only to about chest level
- Feet planted and shoulder blades pinned
Common mistakes
- Bench off center: one side gets more tension, so line it up exactly between the pulleys.
- Bending elbows to move more weight: you lose isolation, so lock the angle and lighten up.
- Opening too wide: it stresses the shoulder, so stop your hands at chest level.
- Dropping the handles when done: the stack slams, so return them under control.
How to make it easier or harder
To regress, use light dumbbell flys or a pec deck machine. To progress, switch to an incline bench, add pauses at full contraction or work one arm at a time.
Sets and reps for your goal
Hypertrophy
3 x 10-15 · rest 60 s3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.
Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.
A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.
Check your form
Film yourself from the side or ask someone to watch, then tick what you get right.
Frequently asked questions
What is the advantage of cable flys over dumbbell flys?
Cables keep tension at the top of the movement, where dumbbells barely load your chest. Your pecs work through the entire arc, which helps the squeeze and the pump.
What height should the pulleys be for flat bench cable flys?
At the lowest setting, so the cables pull from below and out to the sides relative to your body on the bench. That way the resistance matches the arc of the fly.