Atlas
Flat Bench Leg Raise: starting position Flat Bench Leg Raise: end position

Shoulder Raises · Abs

Flat Bench Leg Raise

A shoulder raises exercise that works the abs. Beginner level, using bodyweight.

The flat bench leg raise is done lying face up on a flat bench, holding it behind your head, as you lift nearly straight legs to vertical. The bench lets your legs drop below horizontal, which is not possible on the floor. It is a beginner exercise for training your abs and pelvic control.

BeginnerBodyweightHomeParkGym

Muscles worked

PrimaryAbs

The hip flexors, mainly the iliopsoas, lift the legs while the rectus abdominis keeps your lower back from arching and curls the pelvis at the top. The obliques help stabilize your torso.

Setup and loading

Lie with your hips at the end of the bench or fully on it and grip the bench behind your head. To make it easier, bend your knees; to make it harder, straighten your legs and lower more slowly.

How to do the flat bench leg raise step by step

  1. Lie face up on the flat bench and grab its sides behind your head.
  2. Extend your legs together with a slight knee bend and press your lower back into the pad.
  3. Breathe in, then exhale as you raise your legs until they are vertical over your hips.
  4. At the top, lift your pelvis slightly off the bench by curling your lower back.
  5. Breathe in and lower your legs slowly without your lower back leaving the bench.
  6. Stop just before your back starts to arch and lift again.

Form cues

  • Lower back flat on the way down
  • Legs together and nearly straight
  • Curl the pelvis at the top
  • Slow descent, no dropping

Common mistakes

  • Arching your back as you lower: stresses the spine; shorten the range or bend your knees.
  • Swinging your legs: momentum replaces your abs; take three seconds up and down.
  • Stopping at vertical without curling: only hip flexors work; lift your pelvis slightly.
  • Pulling hard with your arms: shifts the effort; grip only to anchor your torso.

How to make it easier or harder

If keeping your back flat is hard, start with bent knee hip raises. To progress, pause with your legs a few inches above the bench or move on to hanging leg raises.

Advertisement

Sets and reps for your goal

Hypertrophy

3 x 10-15 · rest 60 s

3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.

Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

Do leg raises work abs or hip flexors?

Both. The hip flexors lift your legs while your abs work mainly to stop your lower back from arching and to curl your pelvis at the top. If you never lift your pelvis, it is mostly a hip exercise.

Why do leg raises hurt my lower back?

Usually because your lower back arches as the legs descend and your abs cannot resist the lever. Shorten the range, bend your knees and keep your back pressed against the bench.

Sports it suits

Gear for this exercise

As an Amazon Associate, Muscle Atlas earns from qualifying purchases.

Variations and similar exercises

Advertisement