Atlas
Weighted Bench Dip: starting position Weighted Bench Dip: end position

Dips · Triceps

Weighted Bench Dip

A dips exercise that works the triceps. Intermediate level, using bodyweight.

Weighted bench dips are dips with your hands on a bench behind you, your feet on another bench or the floor, and a weight plate resting on your thighs. The added load turns a simple move into a serious triceps challenge. It is intermediate, so master 15 to 20 unweighted bench dips first.

IntermediateBodyweightHomeParkGym

Muscles worked

PrimaryTriceps
SecondaryChest, Shoulders

Your triceps extend the elbows and do most of the work. Your front delts and chest assist, and the arms-behind-the-body position demands good shoulder mobility.

Setup and loading

Set up two parallel benches, or one bench with your heels on the floor, and center a plate on your thighs. Start with a light plate and increase it only when you can do 10 to 12 reps with no pain in the front of your shoulder.

How to do the weighted bench dip step by step

  1. Sit on the edge of a bench, place your hands beside your hips with fingers forward, and set your feet on another bench.
  2. Have a partner place a plate, or set it yourself, centered on your thighs near your hips.
  3. Slide your hips off the bench and support yourself with your arms straight and your back close to the edge.
  4. Inhale and bend your elbows straight back to lower your hips until your arms reach about 90 degrees.
  5. Exhale and press the bench with your palms to extend your elbows and rise.
  6. Keep your shoulders down and your back close to the bench throughout the set.

Form cues

  • Back stays close to the bench
  • Elbows travel back, not out
  • Lower only to about 90 degrees
  • Shoulders down and chest open the whole time

Common mistakes

  • Dipping too deep: it strains the front of the shoulder; stop near 90 degrees.
  • Hips drifting away from the bench: it loads the shoulder more; stay close to the edge.
  • Poor plate placement: it can slide off; center it on your thighs near your hips.
  • Flaring your elbows: the triceps work less; drive them straight back.

How to make it easier or harder

To make it easier, remove the plate and put your feet on the floor with bent knees. To progress, use a heavier plate or move to parallel bar dips, which allow heavier loading with a better shoulder position.

Advertisement

Sets and reps for your goal

Hypertrophy

3-4 x 8-12 · rest 60-90 s

3-4 sets of 6-12 reps (up to 15-20 on isolation exercises) at 65-80% of your max. Rest 1 to 2 minutes.

Get close to failure (0-3 reps in reserve) and control the lowering for 2-3 seconds. Accumulate 10-20 sets per muscle per week.

Max Strength

4-5 x 3-6 · rest 2-3 min

3-6 sets of 1-6 reps at 80-90% of your max (1RM). Rest 2 to 5 minutes.

Leave 1-3 reps in reserve. If your technique breaks down, lower the weight: strength is built with good reps.

A guide for healthy adults. Adjust the load to your level and see a professional if you have an injury.

Check your form

Film yourself from the side or ask someone to watch, then tick what you get right.

0 of 4

Frequently asked questions

Are bench dips bad for your shoulders?

They can bother people with limited shoulder mobility because your arms end up behind your body. If you lower only to 90 degrees and keep your back close to the bench, most people tolerate them well. If it hurts, switch to parallel bar dips.

When should I add weight to bench dips?

Once you can complete 15 to 20 clean reps with your feet elevated and no discomfort. Start with a light plate on your thighs and increase gradually while keeping the same range of motion.

Sports it suits

Gear for this exercise

As an Amazon Associate, Muscle Atlas earns from qualifying purchases.

Variations and similar exercises

Advertisement